Cluster configuration not synced for Juniper

Vendor

Juniper

Description

For devices that support full configuration synchronization, Indeni will alert if the configuration is out of sync.

Remediation Steps

Log into the device and synchronize the configuration across the cluster.

1. Run "show chassis cluster information configuration-synchronization" command to review configuration synchronization status of a chassis cluster (Junos OS Release 12.1X47-D10 or later).

2. Check the activation and last sync status if these options are enabled.

3. Check the link connectivity.

4. Check the cluster configuration for synchronization.

5. Review this article on Juniper TechLibrary: Operational Commands

6. Contact Juniper Networks Technical Assistance Center (JTAC) if further assistance is required.

How does this work?

This script logs into the Juniper JUNOS-based device using SSH and retrieves the output of the "show chassis cluster status" command. The output includes the status of all redundancy groups across the cluster.

Why is this important?

This script logs into the Juniper JUNOS-based device using SSH and retrieves the output of the "show chassis cluster status" command. The output includes the status of all redundancy groups across the cluster.

Without Indeni how would you find this?

The administrator has to run the "show chassis cluster status" on the device to find whether the cluster member is active or not.


View Source Code